PA Chassis Version 1.0
Entering the service menu with user remote control;
Enter key “1972” when main menu appears on the screen.
Use channel button to navigate and use volume button to change the value settings.
Beko 42 Plasma TV Service Menu
Auto To adjust the general brightness
RS232 Setting 19200 Slip speed for software downloads
Customer Logo X To choose the customer logo, if available (1, 2, etc.)
Operation Time - Shows the operation time since first switch on, can be resetted by
- To adjust the general color settings, normal value is: RGB offset 7
and RGB gain 128
Power On Input Last Defines which input is active after switching on the unit
- Shows temperature threshold for temperature alert function:
Temp1: 60°C; Temp2: 65°C; Temp3: 63°C
also shows all time Max and Min temperature, which can be
resetted by technician
Full Mask off Available functions: inverted, red, green, blue, full white. Might
help against Burn In
Sub Volume - Defines volume setting of each single input separately
- Soft-/Hardware version
Resets all settings to factory defaults, also erases all channel
Photo credit to www.tripadvisor.com
General Guidance Beko 42 Plasma TV
An lsolation Transformer should always be used during the servicing of a receiver whose chassis is not isolated from the AC power line. Use a transformer of adequate power rating as this protects the technician from accidents resulting in personal injury from electrical shocks.
It will also protect the receiver and it's components from being damaged by accidental shorts of the circuitary that may be inadvertently introduced during the service operation.
If any fuse (or Fusible Resistor) in this monitor is blown, replace it with the specified.
When replacing a high wattage resistor (Oxide Metal Film Resistor, over 1W), keep the resistor 10mm away from PCB.
Keep wires away from high voltage or high temperature parts
Before you entering Beko 42 plasma TV factory mode to change any value on the factory service mode, please write down all the original factory settings. tvservicemenu are not responsibility for any damage, data error and unwanted effect after using our service code and information on these page.
Original remote or universal remote control needed as a tools to program the factory mode (Recommended use the original remote control).
If the code above do not match to your television please browse another service code in sitemap page.