Electrical adjustments Mode service
The signal processor IC 7015 (STV2246 or STV 2248) is controlled through the I²C μC IC 7600. For this reason the
Most adjustments should be made through the factory mode menu.
- Enter into factory mode: There are two ways to enter the factory mode
- Shorting pin 7 of μC (7600) to ground and then connecting the appliance.. In this case the controls
(volume, brightness, contrast and saturation) are preset at half its position.
- Placing the receiver in the program 75 and by simultaneously pressing the button on the remote control command. + And OSD menu key on the
Local keyboard receptor for 4 seconds.
The service mode will be indicated by the appearance of the symbol S in the lower left corner of the screen.
- Enter into factory mode: While in service mode, the menu by pressing the OSD (+) button on the remote control.
Press the CH + or CH- buttons to select the parameter to be modified.
Change value use volume button.
Photo by travelblog.ticktab.com
Before you entering ORION & PACIFIC TV Chassis CTS-AA factory mode to change any value on the factory service mode, please write down all the original factory settings. tvservicemenu are not responsibility for any damage, data error and unwanted effect after using our service code and information on these page.
Original remote or universal remote control needed as a tools to program the factory mode (Recommended use the original remote control).
If the code above do not match to your television please browse another service code in sitemap page.
Universal Remote - Service Mode - TV Factory menu codes
You are reading ORION CTS-AA TV Service Menu. Bookmark the ORION CTS-AA TV Service Menu page to your favorite.
https://tvservicemenu.blogspot.com/2014/12/orion-cts-aa-tv-service-menu.html.
Author : Meilyn, Ricky and Akzai Rajali
Editor : Denny Wowor
ORION CTS-AA TV Service Menu (All TV Service Menu Code)
5
stars -
"ORION CTS-AA TV Service Menu"
by Admin 2
The service mode will be indicated by the appearance of the symbol S in the lower left corner of the screen.
- Enter into factory mode Written on December 27, 2014