AIWA TV-12115 and AIWA TV-A2118
All settings related to sensor mode are made using a standard remote control transmitter RC-6VT06 type, which is fitted with AIWA TV-C142 / 86-LB4-951-010 receivers. However, for convenience service mode servicing, it is recommended to make minor modifications to them.
The service mode must be serviced each time the EEPROM non-volatile memory is replaced, and also in cases of replacement of essential elements in deflection and power supply systems.
The set parameters of the service mode are signaled on the screen in the form of OSD messages.
Before entering the service mode, the tester must be connected to the antenna input of the receiver press the [TEST] button on the remote control transmitter; the receiver will enter the so-called ..Aging Mode " receiver), for achieving proper service adjustment menu it is necessary. remaining in .Aging Mode ", press one from the [CHANNEL] buttons on the remote control Confirmation of entering the service adjustment mode is the display on the screen relevant service menu, example:
The receiver's operating mode called "Aging Mode" is mainly used in the production process for
heating targets and receiver regulation In operating conditions, it can be helpful in assessing correctness receiver tuning (AFT function), and also allows you to read the actual lifetime of the receiver {function HEX).
• to activate the receiver warm-up mode (Aging Mode), press the receiver after starting remote control [TEST] button, the following message will appear on the screen: The ..HEX "function enables the readout of the receiver's total operating time. The readout value is given in the hexadecimal notation If the total operating time of 7FFFne>: (32768) is exceeded, then the automatic reset indication. Writing the value of the parameter "HEX" can also be reset at any time, to do this you must use the [FINISH] button.
The selection of individual control parameters is made using the [CH +] or [CH-] buttons on the remote control Change. the value of the selected parameter is made by [VOL +] or [VOL- J.
The [FINISH] button can be used to reset the hour meter of the receiver.
AIWA A2110 TV Service Menu
Universal Remote - Service Mode - TV Factory menu codes
You are reading AIWA A2110 TV Service Menu. Bookmark the AIWA A2110 TV Service Menu page to your favorite.
https://tvservicemenu.blogspot.com/2020/04/aiwa-a2110-tv-service-menu.html.
Author : Meilyn, Ricky and Akzai Rajali
Editor : Denny Wowor
AIWA A2110 TV Service Menu (All TV Service Menu Code)
5
stars -
"AIWA A2110 TV Service Menu"
by Admin1
AIWA A2110 TV Service Menu can use for :
AIWA TV-12115 and AIWA TV-A2118 ,
All settings related to sensor mode are made using a standard remote control transmitter RC-6VT06 type, which is fitted with AIWA TV-C142 / 86-LB4-951-010 receivers. However, for convenience service mode servicing, it is recommended to make minor modifications to them. Written on April 21, 2020